The Quadrino Flight Controller is a ready - to- fly alternative to the complicated process of gathering the many separate pieces required to make a MultiWii multi-rotorcopter
The Quadrino includes the Arduino micro-controller, Gyro, Accelerometer, Barometer*, Magnetometer*, and on-board usb interface. Plugin your radio receiver channels and ESC motor wires and you are ready-to- fly.
The Quadrino supports all MultiWii features such as auto-level mode (acc mode), heading hold (mag mode), and altitude hold (baro). There is a cheaper alternative that removes the magnetometer and barometer. If you are currently flying a GAUI 344 or KK board you will be shocked at the improvement!
Features
- 100% fully arduino compatible. (based on Arduino Nano v3)
- Uses stock MultiWii source code requiring only a few #define parameters to be set based on your setup.
- 400KHz I2C bus supported.
- Servo ports for camera mounts (SRV1 & SRV2). For camera stabilization.
- Works in Quad+, QuadX and also Tri or Hex/Y6 copters.
- Mini-USB connector on board - direct connection!
- Protection diode prevents USB from powering ESCs/motors, but powers receiver
- Forget the datasheet at home, all headers, signals, and diagrams are labeled on the PCB!
- 62mil PCB is strong and sturdy to survive hard crashes or rough landings.
- 8 mounting holes support most standard mounts.
- Lower control-loop cycle time than popular Wii/nunchuk units translates to more stable flight . (avg. 2500 versus 4500.)
- Wiring can be pulled up through the center of the PCB for less wire mess
* Quadrino ZOOM - Quadrino Basic plus BMP085 Barometer and HMC5883 Magnetometer - Baro and Mag provides altitude and heading hold features.
NOW IN STOCK! Email us to order!
PRICE: $115.00CAD BASIC $160.00CAD ZOOM